Replacing bulbs

Bulbs may become very hot while illuminated. Before replacing bulbs, turn off the lights and wait until the bulbs cool down. Otherwise, there is a risk of sustaining a burn injury.

Bulbs may become very hot while illuminated. Before replacing bulbs, turn off the lights and wait until the bulbs cool down. Otherwise, there is a risk of sustaining a burn injury.

Replace any bulb only with a new bulb of the specified wattage. Using a bulb of different wattage could result in a fire. For the specified wattage of each bulb, refer to “Bulb chart”.

Replace any bulb only with a new bulb of the specified wattage. Using a bulb of different wattage could result in a fire. For the specified wattage of each bulb, refer to “Bulb chart”.

See also:

Combination meter illumination
When the ignition switch is turned to the “ON” position, the various parts of the combination meter are illuminated in the following sequence: 1. Warning lights, indicator lights, meter need ...

SRS airbag system servicing
WARNING ● When discarding an airbag module or scrapping the entire vehicle damaged by a collision, consult your SUBARU dealer. ● The SRS airbag has no userserviceable parts. Do not use ...

Tire pressure monitoring system (TPMS) (U.S.-spec. models)
Type A Type B The tire pressure monitoring system provides the driver with the warning message indicated by sending a signal from a sensor that is installed in each wheel when tire p ...