Displaying satellite radio ID of tuner

When you activate satellite radio, you should have your satellite radio tuner ID ready because each tuner is identified by its unique satellite radio tuner ID.

The satellite radio ID will be needed when you activate satellite radio and receive satellite radio customer support.

The satellite radio ID can be found on the audio display by tuning the channel to “0”.

Turn the “TUNE/TRACK/CH” dial to select the satellite radio channel.

NOTE
For Sirius, change the display to an indication mode other than the channel number after performing the above operation.

    See also:

    Driving on grades
    ● Before going down a steep hill, slow down and shift into lower gear (if necessary, use 1st gear) in order to utilize the overheating of your vehicle’s brakes. Do not make sudden downshifts ...

    Reclining the seatback (Outback)
    WARNING To prevent the passenger from sliding under the seatbelt in the event of a collision, always put the seatback in the upright position while the vehicle is in motion. CAUTION If the vehi ...

    Tire pressure monitoring system (TPMS) (if equipped)
    The tire pressure monitoring system provides the driver with a warning message by sending a signal from a sensor that is installed in each wheel when tire pressure is severely low. The tire pre ...