Windshield wiper blade assembly

1. Raise the wiper arm off the windshield.

1) Open the cover

1) Open the cover
2) Pull down the wiper blade

2. Remove the wiper blade assembly by opening the cover and pulling it down in the direction shown in the illustration.

3. Install the wiper blade assembly to the wiper arm. Make sure that it locks in place.

4. Hold the wiper arm by hand and slowly lower it in position.

    See also:

    Construction
    The generic name of each cord material used in the plies (both sidewall and tread area) of this tire. For example, “PLIES: TREAD 2 STEEL + 2 POLYESTER SIDEWALL 2 POLYESTER” ...

    Parking tips
    When parking your vehicle, always perform the following procedure. - Apply the parking brake firmly. - For MT models, put the shift lever in the “1” (1st) position when on an upgrade or the “R ...

    Reclining the seatback (Outback)
    WARNING To prevent the passenger from sliding under the seatbelt in the event of a collision, always put the seatback in the upright position while the vehicle is in motion. CAUTION If the vehi ...