Checking the fluid level when the fluid is cold
When the fluid level has to be checked without time to warm up the automatic transmission, check to see that the fluid level is between the lower level and upper level on the “COLD” range. If it is below that range, add fluid up to the upper level.
Be careful not to overfill.
Be careful not to spill automatic transmission fluid when adding it.
If automatic transmission fluid touches the exhaust pipe, it may cause a bad smell, smoke, and/or a fire. If automatic transmission fluid gets on the exhaust pipe, be sure to wipe it off.
See also:
Cooling or dehumidifying
Cooling or dehumidifying
1) ON position
For cooling and dehumidification of the
passenger compartment, performing the
following steps will allow air to flow
through the instrument panel outl ...
Two separate circuits
Your vehicle has a dual circuit brake system. Each circuit works diagonally across
the vehicle. If one circuit of the brake system should fail, the other half of the
system still works. If one cir ...
Shift lock release
If the select lever cannot be operated, turn
the ignition switch back to the “ON”
position then move the select lever to the
“P” position with the brake pedal depressed.
If the select lever doe ...