Non-turbo models
It is unnecessary to check the deflection of the drive belt periodically because your engine is equipped with an automatic belt tension adjuster. However, replacement of the belt should be done according to the maintenance schedule in the “Warranty and Maintenance Booklet”. Consult your SUBARU dealer for replacement.
If the belt is loose, cracked or worn, contact your SUBARU dealer.
See also:
Towing and tie-down hooks/holes
The towing hooks should be used only in an emergency (e.g., to free a stuck vehicle
from mud, sand or snow).
CAUTION
● Use only the specified towing hooks and tie-down hooks/holes. Never use ...
Temperature A, B, C
The temperature grades are A (the highest), B, and C, representing the tire’s
resistance to the generation of heat and its ability to dissipate heat when tested
under controlled conditions on a sp ...
Trunk light (Legacy)
1. Push both sides of the light cover, and then remove the cover by pulling it
out.
2. Pull the bulb out of the socket.
3. Install a new bulb.
4. Reinstall the cover. ...