Rear gate – if the rear gate cannot be opened

In the event that you cannot open the rear gate by operating the power door locking switches or the remote keyless entry system, you can open it from inside the cargo area.

1. Remove the access cover at the

1. Remove the access cover at the bottom-center of the rear gate trim.

2. Locate the rear gate lock release lever behind the rear gate trim panel.

Never operate the rear gate lock

Never operate the rear gate lock release lever with fingers because doing so may cause an injury. Always use a screwdriver or a similar tool.

3. Turn the lever to the right position

3. Turn the lever to the right position using a screwdriver.

4. Open the rear gate from outside by holding the rear gate with your hands.

    See also:

    Erasing HomeLink® button memory
    NOTE • Performing this procedure erases the memory of all the preprogrammed buttons simultaneously. The memory of individual buttons cannot be erased. • It is recommended that upon the sale of the v ...

    To decrease the speed (by the “RES/SET” switch)
    Press the “RES/SET” switch to the “SET” side and hold it until the vehicle reaches the desired speed. Then, release the switch. The vehicle speed at that moment will be memorized and treated as ...

    Interior
    While the exterior's looks caused me some disappointment, the Outback's interior has sacrificed nothing. I had one of my favorite test drives in a 2006 Outback, so I was a bit worried that the new ...