To temporarily cancel the cruise control
The cruise control can be temporarily canceled in the following ways.
- Push the “CANCEL” button.
- Depress the brake pedal.
- Depress the clutch pedal (MT models only).
- Shift the select lever into the “N” position (AT models only).
- Shift the shift lever into neutral position (MT models only).
The cruise control set indicator light on the combination meter turns off when the cruise control is canceled.
To resume the cruise control after it has been temporarily canceled and with vehicle speed of approximately 20 mph (32 km/h) or more, push the “RES/ACC” button to return to the original cruising speed automatically.
The cruise control set indicator light on the combination meter will automatically illuminate at this time.
See also:
To engage the service mode
Turn the ignition switch to the “ON”
position, depress and hold the brake
pedal, then press and release the “”
button on the remote control transmitter
three times. The system will pause for 1 ...
Wiper intermittent time control
Wiper intermittent time control
When the wiper switch is in the “” position, turn the dial to adjust the operating interval of the wiper.
The operating interval can be adjusted in nine steps. ...
Category selection
To activate the category search mode, press the “PTY/CAT” button. To deactivate
the category search mode, press the “PTY/CAT” button again.
When in the category search mode, pressing the “FOLDE ...