Erasing picture
1. Select the “Picture Erase” menu by
operating the “TUNE/TRACK/CH” dial. For
details, refer to “Audio settings (type D
audio)”. If no pictures are saved,
“No Data” is displayed. Press the
button to return to the “Screen Saver”
mode.
2. Select the preferred picture by operating the “TUNE/TRACK/CH” dial.
3. Operate the “TUNE/TRACK/CH” dial to select “OK” to erase the picture or “Cancel” to cancel the operation.
See also:
Unlocking the rear gate (Outback)
Pressing the “” button unlocks the
rear gate.
An electronic chirp will sound twice and the turn signal lights will flash twice. ...
When “CHECK DEVICE” is displayed
This message is displayed under the
following conditions.
- When there is a short in the USB bus
- When a non-corresponding device (for
example a USB mouse) is connected
- When a non-correspo ...
Selection of manual mode
NOTE
Please read the following points carefully and bear them in mind when using the manual mode.
• If you attempt to shift down when the engine speed is too high, i.e., when a downshift would push ...
