Subaru Outback manuals

Subaru Outback (BR): Drive belts

It is unnecessary to check the deflection of the drive belt periodically because your engine is equipped with an automatic belt tension adjuster. However, replacement of the belt should be done according to the maintenance schedule in the “Warranty and Maintenance Booklet”. Consult your SUBARU dealer for replacement.

If the belt is loose, cracked or worn, contact your SUBARU dealer.

READ NEXT:

 Manual transmission oil

 Checking the oil level in Manual transmission

  Non-turbo models 1) Yellow handle   Turbo models 1) Yellow handle Check the oil level monthly. 1. Park the vehicle on a level surface and stop the engine. 2. Pull out the level

SEE MORE:

 To decrease the speed (by the “RES/SET” switch)

Press the “RES/SET” switch to the “SET” side and hold it until the vehicle reaches the desired speed. Then, release the switch. The vehicle speed at that moment will be memorized and treated as the new set speed. U.S.-spec. models When the difference between the actual vehicle speed

 Front Vehicle Speed Sensor

A: REMOVAL 1) Remove the transmission assembly from the vehicle. <Ref. to 5AT-37, REMOVAL, Automatic Transmission Assembly.> 2) Disconnect the rear vehicle speed sensor connector. NOTE: Secure the transmission harness to the transmission body using wire etc. 3) Remove the extension case.

© 2010-2025 Copyright www.suoutback.com