Subaru Outback (BR): Towing with all wheels on the ground
WARNING
● Never turn the ignition switch to the “LOCK” position while the vehicle is being towed because the steering wheel and the direction of the wheels will be locked.
● Remember that the brake booster and power steering do not function when the engine is not running. Because the engine is turned off, it will take greater effort to operate the brake pedal and steering wheel.
CAUTION
● If transmission failure occurs, transport your vehicle on a flatbed truck.
● Do not run the engine while being towed using this method. Transmission damage could result if the vehicle is towed with the engine running.
● For AT and CVT models, the traveling speed must be limited to less than 20 mph (30 km/h) and the traveling distance to less than 31 miles (50 km). For greater speeds and distances, transport your vehicle on a flat-bed truck.
1. Release the parking brake and put the transmission in neutral.
2. The ignition switch should be in the “Acc” position while the vehicle is being towed.
3. Take up slack in the towline slowly to prevent damage to the vehicle.
READ NEXT:
Electronic parking brake – if the electronic parking brake cannot be released
WARNING
● When the electronic parking brake cannot be released, the electronic parking
brake system may malfunction. Driving in such conditions may cause an unexpected
accident. Contact you
Rear gate (Outback) – if the rear gate cannot be unlocked
In the event that you cannot unlock the rear gate by operating the power door
locking switches or the remote keyless entry system, you can unlock it from inside
the cargo area.
1. Remove the ac
Moonroof – if moonroof cannot be closed
If the moonroof cannot be closed with the moonroof switch, you can close the
moonroof manually.
1. Take out the screwdriver from the tool bucket.
2. Open the overhead console. Refer to “Overhead
SEE MORE:
Temperature sensors
1) Solar sensor
2) Interior air temperature sensor
The automatic climate control system employs several sensors. These sensors are
delicate. If they are treated incorrectly and become damaged, the system may not
be able to control the interior temperature correctly. To avoid damaging the sen
AUX Input Terminal
A: REMOVAL
1. AUX INPUT TERMINAL
1) Disconnect the ground cable from battery.
2) Remove the console front cover assembly.
MT model
1. Remove the shift knob.
2. Release the clips and claws, then pull up the console front cover assembly.
NOTE:
Turn over the front center pocket mat (a) and pull u
