Subaru Outback (BR): To decrease the speed (by brake pedal)
Subaru Outback (BR) 2010-2015 Owners Manual / Starting and operating / Cruise control / To change the cruising speed / To decrease the speed (by brake pedal)
1. Depress the brake pedal to release cruise control temporarily.
2. When the speed decreases to the desired speed, press the “RES/SET” switch to the “SET” side once. Now the desired speed is set and the vehicle will keep running at that speed without depressing the accelerator pedal.
READ NEXT:
Cruise control indicator light
The cruise control indicator light illuminates when the ignition switch is turned
to the “ON” position and turns off after approximately 3 seconds.
The light illuminates when the “CRUISE”
Cruise control activation indicator light
The indicator light for cruise control activation illuminates upon turning the ignition switch to the “ON” position and remains lit for around 3 seconds.
This light becomes illuminated
SEE MORE:
How to use Subaru Select Monitor, data, modes
A: OPERATION
1. HOW TO USE SUBARU SELECT MONITOR
NOTE:
For detailed operation procedures, refer to "PC application help for Subaru Select Monitor".
If communication is not possible between the electronic parking brake control module and the Subaru Select Monitor, check the
Remote engine start system (dealer option)
WARNING
● Do not remote start a vehicle in an enclosed environment (e.g. closed garage).
Prolonged operation of a motor vehicle in an enclosed environment can cause a harmful
build-up of Carbon Monoxide. Carbon Monoxide is harmful to your health. Exposure
to high levels of Carbon Monoxi
© 2010-2024 Copyright www.suoutback.com
