Subaru Outback (BR): To temporarily cancel the cruise control
The cruise control can be temporarily canceled in the following ways.
● Press the “CANCEL” button.
● Depress the brake pedal.
● Depress the clutch pedal (MT models only).
● Shift the select lever into the “N” position (AT and CVT models).
● Shift the shift lever into the neutral position (MT models only).
The cruise control set indicator light in the combination meter turns off when the cruise control is canceled.
To resume the cruise control after it has been temporarily canceled and with vehicle speed of approximately 20 mph (32 km/h) or more, press the “RES/SET” switch to the “RES” side to return to the original cruising speed automatically.
The cruise control set indicator light in the combination meter will automatically illuminate at this time.
READ NEXT:
To turn off the cruise control
There are two ways to turn off the cruise control:
● Press the “CRUISE” main switch button again.
● Turn the ignition switch to the “Acc” or “LOCK” position (but only when th
To increase the speed (by the “RES/ SET” switch)
Press the “RES/SET” switch to the “RES” side and hold it until the vehicle reaches
the desired speed. Then, release the switch. The vehicle speed at that moment will
be memorized and tre
SEE MORE:
Voice command system
Talk switch
To turn on the voice command system, press the talk switch
briefly. To turn off the voice command
system, press the talk switch for more
than 1.5 seconds.
The commands available for the voice command system are listed in the following
chart.
Photosensors
The mirror has a photosensor attached on both the front and back sides. During
nighttime driving, these sensors detect distracting glare from vehicle headlights
behind you and automatically dim the mirror to eliminate glare and preserve your
vision. For this reason, use care not to cover the
