Subaru Outback (BR): ABS warning light
The ABS warning light illuminates when the ignition switch is turned to the “ON” position and turns off after approximately 2 seconds.
This is an indication that the ABS system is working properly.
CAUTION
● If any of the following conditions occur, we recommend that you have the ABS system repaired at the first available opportunity by your SUBARU dealer.
– The warning light does not illuminate when the ignition switch is turned to the “ON” position.
– The warning light illuminates when the ignition switch is turned to the “ON” position, but it does not turn off even when the vehicle speed exceeds approximately 12 km/h (8 mph).
– The warning light illuminates during driving.
– The warning light flashes.
● When the warning light is on (and brake system warning light is off), the ABS function shuts down; however, the conventional brake system continues to operate normally.
● When the warning light is flashing, the ABS system may be malfunctioning. However, the conventional brake system continues to operate normally.
NOTE
If the warning light behavior is as described in the following, the ABS system may be considered normal.
● The warning light illuminates right after the engine is started but turns off immediately, remaining off.
● The warning light remains illuminated after the engine has been started, but it turns off when the vehicle speed reaches approximately 8 mph (12 km/h).
● The warning light illuminates during driving, but it turns off immediately and remains off.
When driving with an insufficient battery voltage such as when the engine is jump started, the ABS warning light may illuminate. This is due to the low battery voltage and does not indicate a malfunction. When the battery becomes fully charged, the light will turn off.
READ NEXT:
Electronic Brake Force Distribution (EBD) system
The EBD system maximizes the effectiveness of the brakes by allowing the rear
brakes to supply a greater proportion of the braking force. It functions by adjusting
the distribution of braking forc
Steps to take if EBD system malfunctions
If a malfunction occurs in the EBD system, the system stops working and the brake
system warning light and ABS warning light illuminate simultaneously.
The EBD system may be malfunctioning if the
Vehicle Dynamics Control system
WARNING
Always use the utmost care in driving – overconfidence because you are driving
with a Vehicle Dynamics Control system equipped vehicle could easily lead to a serious
accident.
CAUTION
SEE MORE:
Hill Holder function
The electronic parking brake system has a Hill Holder function. If the Hill Holder
function is activated, the parking brake will be automatically applied when stopping
on an uphill slope with the brake pedal depressed. In this case, the brake system
warning light and the indicator light on the
High beam light bulbs
1. Remove the air intake duct (right-hand side). For the method to remove the
air intake duct, refer to “Removing air intake duct” F11-7.
Left-hand side
2. Use a screwdriver to remove the secured clip of the washer tank. To make it
easy to access the bulb, move the washer tank to the hor
