Subaru Outback (BR): Brake assist system
WARNING
Do not be overconfident about the brake assist. It is not a system that brings more braking ability to the vehicle beyond its braking capability. Always use the utmost care when driving regarding vehicle speed and safe distance.
CAUTION
When you need to brake suddenly, continue depressing the brake pedal strongly to bring the effect of the brake assist.
Brake assist is a driver assistance system. It assists the brake power when the driver cannot depress the brake pedal strongly and the brake power is insufficient. Brake assist generates the brake power according to the speed at which the driver depresses the brake pedal.
NOTE
When you depress the brake pedal strongly or suddenly, the following phenomena occur. However, even though these occur, they do not indicate any malfunctions, and the brake assist system is operating properly.
● You might feel that the brake pedal is applied by lighter force and generates a greater braking force.
● You might hear the sound of ABS operating from the engine compartment.
READ NEXT:
Disc brake pad wear warning indicators
The disc brake pad wear warning indicators on the disc brakes give a warning
noise when the brake pads are worn.
If a squeaking or scraping noise is heard from the disc brakes while braking,
im
ABS (Anti-lock Brake System)
WARNING
Always use the utmost care in driving – overconfidence because you are driving
with an ABS equipped vehicle could easily lead to a serious accident.
CAUTION
● The ABS system does
ABS system self-check
You may feel a slight shock in the brake pedal and hear the operating sound of
ABS from the engine compartment just after the vehicle is started. This is caused
by an automatic functional test of
SEE MORE:
Continuously Variable Transmission Mounting System
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Lift up the vehicle.
3) Remove the center exhaust pipe. <Ref. to EX(H4SO)-8, REMOVAL, Center Exhaust Pipe.>
4) Remove the heat shield cover.
5) Set the transmission jack under the transmission. Make sure that the support plate
Front Hood
A: REMOVAL
1. FRONT HOOD INSULATOR
Release the clips to remove the front hood insulator.
CAUTION:
Do not reuse any clips damaged during removal. The damaged clip cannot fix the
insulator securely.
Therefore, always replace with a new part.
2. FRONT HOOD SEAL
Remove the clip, and remove the seal.
