Subaru Outback (BR): To install the cover housing
Subaru Outback (BR) 2010-2015 Owners Manual / Interior equipment / Cargo area cover (if equipped) / To install the cover housing
1. To install the cover housing, insert both ends of the cover housing into the retainers.
2. Make sure to fix the front part of the cargo area cover behind the rear seat.
READ NEXT:
Convenient tie-down hooks (if equipped)
CAUTION
The convenient tie-down hooks are designed only for securing light cargo. Never
try to secure cargo that exceeds the capacity of the hooks. The maximum load capacity
is 44 lbs (20 kg) per
Under-floor storage compartment
The subfloor storage compartment is located under the floor of the trunk or cargo
area and can be used to store small items. To open the lid, pull the tab or handle
up.
NOTE
When storing a flat
Rear view camera (if equipped)
Legacy
Outback
A rear view camera is attached to the trunk lid (Legacy) or rear gate (Outback).
When the ignition switch is “ON” and the shift lever (MT models) or select lever
(AT or CV
SEE MORE:
N (Neutral)
This position is for restarting a stalled engine.
In this position the wheels and transmission are not locked. In this position,
the transmission is neutral; the vehicle will roll freely, even on the slightest
incline unless the parking brake or foot brake is applied. Avoid coasting with the
“up” and “down” switch
With radio mode selected
Press the switch to the “” or “”
side briefly to skip to a preset channel. Press the switch to the “”
or “” side for more than 0.5 second
to seek the next receivable station and stop at it.
That station’s frequency will be indicated on the audio d
© 2010-2024 Copyright www.suoutback.com
