Subaru Outback (BR): Floor mat
Retaining pins are located on the driver’s side floor.
The floor mat is secured using the built-in grommets, by placing the grommets over the pins and pushing them downward.
CAUTION
Make sure the driver’s floor mat is placed back in its proper location and correctly secured on its retaining pin. Also, do not use more than one floor mat. If the floor mat slips forward and interferes with the movement of the pedals during driving, it could cause an accident.
READ NEXT:
Cargo area cover (if equipped)
The cargo area cover is provided for covering the cargo area and to protect its
contents from direct sunlight. This cover is detachable to make room for additional
cargo.
Using the cover
To extend the cover, pull the end of the cover out of the housing, then insert
its hooks into the catches as shown. To rewind it, unhook it from the catches and
it will rewind automatically. You
To remove the cover housing
1. Rewind the cover.
2. Hold down the button on the righthand rear quarter panel and lift up the right-hand
cover housing.
3. Remove the cover housing.
SEE MORE:
Rear Differential (VA-type)
A: REMOVAL
The removal procedure for VA-type is included in
"REMOVAL" for T-type. <Ref. to DI-26, REMOVAL,
Rear Differential (T-type).>
B: INSTALLATION
The installation procedure for VA-type is included
in "INSTALLATION" for T-type. <Ref. to DI-28, INSTALLATION,
Rear Differential (T-type).&
Rear Shelf Trim
A: REMOVAL
1) Disconnect the ground cable from battery and wait for at least 60 seconds
before starting work.
CAUTION:
The airbag system is fitted with a backup power supply. After disconnecting the
battery ground cable,
the airbag may operate if you do not wait for 60 seconds before starting the
© 2010-2024 Copyright www.suoutback.com
