Subaru Outback (BR): Dome light switch
1) ON
2) DOOR
3) OFF
The dome light switch has three positions:
ON: The light remains on continuously.
OFF: The light remains off.
DOOR: The dome light illuminates automatically in the following cases.
● Any of the doors or the rear gate (Outback) is opened.
● The doors or the rear gate (Outback) are unlocked using the remote keyless entry transmitter.
● The ignition switch is turned from the “Acc” position to the “LOCK” position. The automatically illuminated dome light remains on for several seconds and then gradually turns off after all doors and the rear gate (Outback) are closed. While the light is on, if any of the following operations are performed, the dome light turns off immediately.
● The ignition switch is turned from the “LOCK” position to “Acc” or “ON” position.
● All doors and the rear gate (Outback) are locked using the remote keyless entry transmitter.
The setting of the period for which the light remains on (OFF delay timer) can be changed by a SUBARU dealer. Contact your SUBARU dealer for details.
READ NEXT:
Map light models and functioning
Models with moonroof
Models without moonroof
To turn on the map light, press the switch.
To turn it off, press the switch again.
When leaving the vehicle, make sure the lights
Door interlock switch
1) Door interlock switch
Although the map light switches are in the OFF position (manually off), the map
lights can be set to illuminate automatically in conjunction with a door opening,
etc. b
Cargo area light (Outback)
1) DOOR
2) OFF
3) ON
The cargo area light switch has three positions.
DOOR: The light illuminates only when the rear gate is opened.
OFF: The light remains off.
ON: The light remains on contin
SEE MORE:
Tongue load
Tongue load
WARNING
If the trailer is loaded with more weight in the back of trailer’s axle than
in the front, the load is taken off the rear axle of the towing vehicle. This may
cause the rear wheels to skid, especially during braking or when vehicle speed is
reduced during cornering, r
Universal Joint
A: REMOVAL
1) Adjust the tilt position of the steering column to the lowest position and
lock the tilt lever.
2) Prevent the steering wheel from turning using the seat belt.
3) Remove the universal joint.
Place alignment marks on universal joint.
Remove the universal joint bolt and remove the
