Subaru Outback (BR): Auxiliary input jack
By connecting a commercial audio product to the vehicle, such as a portable audio player, you can hear its sound via the vehicle’s speaker.
An auxiliary (AUX) input jack is equipped in the center console. A stereo mini pin plug (3.5ø) can be inserted in this jack.
The connection cable is available at electrical appliance or similar stores.
To use the AUX input jack:
1. Connect a portable audio player to the AUX input jack.
2. Press the AUX input selection button “CD/AUX” on the audio control panel to turn on the auxiliary audio input.
3. Play back the portable audio player. Refer to the Owner’s Manual of the portable audio player.
NOTE
● The output sound of the portable audio player is not loud, and the sound via the vehicle’s speakers that are connected to the vehicle audio set is very low. If you turn up the volume of the audio set, the volume becomes louder. However, when you change the player to the other portable audio player, the sound may become a lot louder. Turn down the volume when you change between them.
● In some cases, when the sound volume of the portable audio player is low, the sound becomes bad when you turn up the volume of the vehicle audio system. In this case, adjust the sound volume of the portable audio player.
● In some cases, noise occurs because of a bad connection between the portable player and the audio system. Try cleaning the stereo jack and audio plug.
● If noise is not reduced, check for disconnection of the cord or malfunctions of the portable player.
READ NEXT:
Precautions to observe when handling a compact disc
Use only compact discs (CDs, CD-Rs and CD-RWs) that have the mark shown in the
following illustration. Also, some compact discs cannot be played.
● You cannot use a DualDisc in the CD pla
Audio control buttons (if equipped)
Type A audio
Type B audio
These buttons are located on the spokes of the steering wheel. They allow the
driver to control audio functions without taking his/her hands off the steering
wheel.
MODE button
This button is used to select the desired audio mode. Each time it is pressed,
the mode changes to the next one in the following sequence.
*1: The frequency last received in the selected waveba
SEE MORE:
Taking a phone call and declining an incoming call
To take a phone call: Press the OFF hook switch0
.
To put an incoming call on hold: Press the ON hook switch briefly
.
To decline an incoming call: Press the ON hook switch
for more than 1.5 seconds.
Wiper and washer
WARNING
In freezing weather, do not use the windshield washer until the windshield is
sufficiently warmed by the defroster.
Otherwise the washer fluid can freeze on the windshield, blocking your view.
CAUTION
● Do not operate the washer continuously for more than 10 seconds, or when the
