Subaru Outback (BR): PTY (Program type) group tuning (only FM reception)
Press the “PTY/CAT” button to change to the PTY selection mode. At this time,
the PTY group that you are currently listening to will be displayed for 10 seconds.
In PTY selection mode, “PTY SEL” is displayed on the screen.
PTY (Program type) group selection
In PTY selection mode, press the “PTY” button “”
or “” to change the PTY group by one
step at a time.
Pressing “” changes the PTY group
up by one step. Pressing “” changes the
PTY group down by one step. This operation only changes the display. It does not
change the station that is currently being received.
Seek in PTY (Program type) group
In the PTY selection mode, when the desired PTY group has been selected, pressing
the “SEEK” button “” or “”
seeks within that PTY group. In this case, “PTY SEEK” is displayed on the screen.
Pressing “” seeks up. Pressing “”
seeks down.
The control function returns to the normal mode after approximately 10 seconds.
READ NEXT:
If the PS (Program Service Name) and/or RT (Radio Text) are available, pressing
the “TEXT” button changes the display among PS, RT and frequency. The initial setting
is “PS”.
NOTE
`
1. Press the “FM” or “AM” button to select FM1, FM2, FM3 or AM reception. 2.
Press the “” or “”
side of the “SEEK” button or tune the radio manually until the desired station f
SEE MORE:
A: REMOVAL
1) Lift up the vehicle, and then remove the front wheels.
2) Remove the front strut.
Place an alignment mark on the camber adjusting bolt and strut.
Remove the brake hose bracket.
Remove the ABS wheel speed sensor harness.
Remove the two bolts securing the front axle housing t
● Check that the vehicle and vehicle-tohitch mounting are in good condition.
If any problems are apparent, do not tow the trailer.
● Check that the vehicle sits horizontally with the trailer attached. If the
vehicle is tipped sharply up at the front and down at the rear, check the t
© 2010-2024 Copyright www.suoutback.com