Subaru Outback (BR): Seek tuning (SEEK)
If you press the “” or “”
side of the “SEEK” button briefly, the radio will automatically search for a receivable
station and stop at the first one it finds. This function may not be available,
however, when radio signals are weak. In such a situation, perform manual tuning
to select the desired station.
READ NEXT:
If you press the “SCAN” button, the radio will switch to the scan mode. In this
mode, the radio scans through the radio band until a station is found. The radio
will stop at the station for
Press the “PTY/CAT” button to change to the PTY selection mode. At this time,
the PTY group that you are currently listening to will be displayed for 10 seconds.
In PTY selection mode, “PT
If the PS (Program Service Name) and/or RT (Radio Text) are available, pressing
the “TEXT” button changes the display among PS, RT and frequency. The initial setting
is “PS”.
NOTE
`
SEE MORE:
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the air intake boot.
H4 model: <Ref. to IN(H4DOTC)-10, REMOVAL, Air Intake Boot.>
H6 model: <Ref. to IN(H6DO)-7, REMOVAL, Air Intake Boot.>
3) Remove the VDC control module & hydraulic control unit (VDCCM&H/U)
The light will turn on when the ignition switch is set to the "ON" position and will automatically turn off after about 2 seconds. Additionally, the light will illuminate if the Vehicle Dynamics Control OFF switch is pressed to deactivate the Vehicle Dynamics Control system in Subaru Out
© 2010-2024 Copyright www.suoutback.com