Subaru Outback (BR): Heater operation
NOTE
● When the “” button or “”
button is pressed the air conditioner compressor automatically operates to quickly
defog the windshield. However the indicator on the air conditioner button will not
illuminate. At the same time, the air inlet selection is automatically set to “outside
air” mode.
● Warm air also comes out from the right and left air outlets. To stop warm airflow
from these outlets, turn the corresponding wheel to the “”
position.
READ NEXT:
To direct warm air to the windshield and front door windows:
1. Set the air inlet selection button to the OFF position.
2. Press the “” button.
3. Turn the temperature control dial all the way
To direct warm air toward the floor and the windshield:
1. Set the air inlet selection button to the OFF position.
2. Press the “” button.
3. Set the temperature control dial to the most comfor
To direct warm air toward the floor:
1. Set the air inlet selection button to the OFF position.
2. Press the “” button.
3. Set the temperature control dial to the most comfortable level.
4. Se
SEE MORE:
To clean the navigation monitor, wipe it with a silicone cloth or with a soft
cloth. If the navigation monitor is extremely dirty, clean it with a soft cloth
moistened with neutral detergent then carefully wipe off any remaining detergent.
NOTE
● Do not spray neutral detergent directly o
This indicator light illuminates under the following conditions.
● when the light switch is turned to the “”
or “” position
● when the light switch is in the “AUTO” position and the headlights illuminate
automatically
© 2010-2024 Copyright www.suoutback.com