Subaru Outback manuals

Subaru Outback (BR): Air inlet selection button (Manual climate Control system)

Subaru Outback (BR) 2010-2015 Owners Manual / Climate control / Manual climate control system (if equipped) / Manual climate Control panel / Air inlet selection button (Manual climate Control system)

ON position (recirculation): Interior air is recirculated inside the vehicle.

 

ON position (recirculation): Interior air is recirculated inside the vehicle.

Press the air inlet button to the ON position. The indicator light will illuminate. Place this button in the ON position when you wish to cool the cabin quickly or are driving on a dusty road.

OFF position (outside air): Outside air is drawn into the passenger compartment. Press the air inlet button again to the OFF position. The indicator light will turn off. Place this button in the OFF position when you reach a road that is not dusty and when you wish to achieve a comfortable temperature in the cabin.

WARNING

Continued operation in the ON position may fog up the windows. Switch to the OFF position as soon as the outside dusty condition clears.

READ NEXT:

 Heater operation

NOTE ● When the “” button or “” button is pressed the air conditioner compressor automatically operates to quickly defog the windshield. However the indicator on the air conditioner

 Defrosting or defogging the windshield

To direct warm air to the windshield and front door windows: 1. Set the air inlet selection button to the OFF position. 2. Press the “” button. 3. Turn the temperature control dial all the way

 Heating and defrosting

To direct warm air toward the floor and the windshield: 1. Set the air inlet selection button to the OFF position. 2. Press the “” button. 3. Set the temperature control dial to the most comfor

SEE MORE:

 Clock

NOTE Your SUBARU dealer can change the settings of activating/deactivating the automatic adjustment of the clock by the GPS (Global Positioning System) (for models with the genuine SUBARU navigation system). Contact your SUBARU dealer for details. The clock shows the time while the ignition

 Rear window wiper blade rubber (Outback)

1. Pull out the end of the blade rubber assembly to unlock it from the plastic support. 2. Pull the blade rubber assembly out of the plastic support. 1) Metal spines 3. If the new blade rubber is not provided with two metal spines, remove the metal spines from the old blade rubber and i

© 2010-2024 Copyright www.suoutback.com