Subaru Outback (BR): Gear position indicator setting (MT models)
The gear position indicator light can be activated or deactivated by performing the following procedure.
1. Turn the ignition switch to the “LOCK” position.
2. Press the trip knob to show “ ” or “ ” on the trip meter display.
The display can be switched as shown in the following illustration by pressing the trip knob.
3. To change the current setting, press the trip knob for at least 2 seconds.
NOTE
● The initial setting for your vehicle of the gear position indicator has been
set for activation “
” at the time of
shipment from the factory.
● It is not possible to change the setting of the gear position indicator when the ignition switch is in the “ON” position. Change the setting when the ignition switch is in the “LOCK” or “Acc” position.
READ NEXT:
Turn signal indicator lights
These lights show the operation of the turn signal or lane change signal.
If the indicator lights do not blink or blink rapidly, the turn signal bulb may
be burned out. Replace the bulb as soon a
High beam indicator light
This light shows that the headlights are in the high beam mode.
This indicator light also illuminates when the headlight flasher is operated.
Indicator light for cruise control in Outback (2010-2015)
The indicator light for cruise control becomes illuminated upon turning the ignition switch to the “ON” position and remains lit for around 3 seconds. Activation of this light al
SEE MORE:
Oil Pressure Switch
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the generator. <Ref. to SC(H4SO)-18,
REMOVAL, Generator.>
3) Disconnect the terminal from oil pressure switch.
4) Remove the oil pressure switch.
B: INSTALLATION
1) Apply liquid gasket to the oil pressure switch
threads.
Li
Charge warning light
If this light illuminates when the engine is running, it may indicate that the
charging system is not working properly.
If the light illuminates while driving or does not turn off after the engine
starts, stop the engine at the first safe opportunity and check the alternator belt.
If the be
