Subaru Outback (BR): Select lever/gear position indicator
Subaru Outback (BR) 2010-2015 Owners Manual / Instruments and controls / Warning and indicator lights / Select lever/gear position indicator
1) Upshift/downshift indicator (AT and CVT models)
This indicator shows the position of the shift lever (MT models) or select lever (AT and CVT models).
READ NEXT:
Upshift/downshift indicator (AT and CVT models)
When the manual mode is selected, the gear position indicator (which shows the
current gear selection) and the upshift/ downshift indicator light up. Refer to
“Automatic transmission/Continuousl
Gear position indicator setting (MT models)
The gear position indicator light can be activated or deactivated by performing
the following procedure.
1. Turn the ignition switch to the “LOCK” position.
2. Press the trip knob to show “
Turn signal indicator lights
These lights show the operation of the turn signal or lane change signal.
If the indicator lights do not blink or blink rapidly, the turn signal bulb may
be burned out. Replace the bulb as soon a
SEE MORE:
Oil Pump
A: REMOVAL
NOTE:
Refer to "Drive Pinion Shaft" for removal procedures. <Ref. to CVT-242, REMOVAL,
Drive Pinion Shaft Assembly.>
B: INSTALLATION
NOTE:
Refer to "Drive Pinion Shaft" for removal procedures. <Ref. to CVT-244,
INSTALLATION, Drive Pinion Shaft
Assembly.>
C: INSPECTION
Check
Automatic Transmission Control Device
A: REMOVAL
1) Remove the transmission assembly from the vehicle.
<Ref. to 5AT-37, REMOVAL, Automatic Transmission Assembly.>
2) Pull out the torque converter assembly. <Ref. to 5AT-63, REMOVAL, Torque Converter Assembly.>
3) Lift up the lever on the rear side of transmission harness
© 2010-2024 Copyright www.suoutback.com
