Subaru Outback (BR): VDC warning light / VDC operation indicator light
Subaru Outback (BR) 2010-2015 Owners Manual / Instruments and controls / Warning and indicator lights / VDC warning light / VDC operation indicator light
The light illuminates when the ignition switch is turned to the “ON” position and turns off several seconds after the engine has started. This lighting pattern indicates that the Vehicle Dynamics Control system is operating normally.
READ NEXT:
Vehicle Dynamics Control warning light
CAUTION
The Vehicle Dynamics Control system provides its ABS control through the electrical
circuit of the ABS system. Accordingly, if the ABS is inoperative, the Vehicle Dynamics
Control system
Vehicle Dynamics Control operation indicator light
The indicator light flashes during activation of the skid suppression function
and during activation of the traction control function.
NOTE
● The light may remain illuminated for a short per
Vehicle Dynamics Control OFF indicator light
The light illuminates when the ignition switch is turned to the “ON” position
and turns off after approximately 2 seconds. The light illuminates when the Vehicle
Dynamics Control OFF switch
SEE MORE:
Woofer
A: REMOVAL
1. SEDAN MODEL
NOTE:
harman/kardon audio system only.
1) Disconnect the ground cable from battery.
2) Remove the rear shelf trim. <Ref. to EI-120, REMOVAL, Rear Shelf Trim.>
3) Remove the woofer.
Remove the screws.
Disconnect the harness connector and remove the woofer assembly
Steering Wheel
A: REMOVAL
1) Disconnect the negative terminal from the battery, and wait for 60 seconds
or more.
2) Set the tire to the straight-ahead position.
3) Remove the driver's airbag module assembly.
Push in the snap pin using a hexagon wrench or equivalent wrapped with a
protective tape to disengag
© 2010-2024 Copyright www.suoutback.com
