Subaru Outback (BR): For AT models
This light flashes if the vehicle is driven with tires of different diameters fitted on its wheels or with the air pressure excessively low in any of its tires.
READ NEXT:
For CVT models
This light illuminates when All-Wheel Drive is disengaged and the drive mechanism
is switched to Front Wheel Drive for maintenance or similar purposes. This light
flashes if the vehicle is driven
VDC warning light / VDC operation indicator light
The light illuminates when the ignition switch is turned to the “ON” position and turns off several seconds after the engine has started. This lighting pattern indicates that the Vehicle
Vehicle Dynamics Control warning light
CAUTION
The Vehicle Dynamics Control system provides its ABS control through the electrical
circuit of the ABS system. Accordingly, if the ABS is inoperative, the Vehicle Dynamics
Control system
SEE MORE:
Extension Case
A: REMOVAL
1) Remove the transmission assembly. <Ref. to
5AT-37, REMOVAL, Automatic Transmission Assembly.>
2) Disconnect the rear vehicle speed sensor connector.
3) Remove the rear vehicle speed sensor.
4) Remove the extension case.
B: INSTALLATION
1) Attach the selected reduction driven
Pressure Sensor
A: INSPECTION
1) Perform a diagnosis code (DTC) check by connecting the Subaru Select
Monitor.
2) If any diagnosis code (DTC) is displayed, refer to "List of Diagnostic
Trouble Code (DTC)" in "HVAC SYSTEM
(DIAGNOSTICS)" section. <Ref. to AC(diag)-53, LIST, List of Diagnostic Trouble
Code (DTC
© 2010-2024 Copyright www.suoutback.com
