Subaru Outback manuals

Subaru Outback (BR): AT OIL TEMP warning light (AT and CVT models)

The AT oil temperature warning light “AT OIL TEMP” illuminates when the ignition switch is turned to the “ON” position and turns off after approximately 2 seconds. If this light illuminates when the engine is running, it may indicate that the transmission fluid temperature is too hot. If the light illuminates while driving, immediately stop the vehicle in a safe place and let the engine idle until the warning light turns off.

READ NEXT:

 Transmission control system warning

If the “AT OIL TEMP” warning light flashes after the engine has started, it may indicate that the transmission control system is not working properly. Contact your nearest SUBARU dealer for se

 Low tire pressure warning light (U.S.-spec. models)

When the ignition switch is turned to the “ON” position, the low tire pressure warning light will illuminate for approximately 2 seconds to check that the tire pressure monitoring system (TP

 Understanding the ABS Warning Light in Your Subaru Outback (BR)

  ABS warning light serves as an essential indicator of the Anti-Lock Braking System's operational status in your Subaru Outback (BR). When you turn the ignition switch to the “ON”

SEE MORE:

 Rear Drive Shaft, General Diagnostic Table

A: REMOVAL 1) Lift up the vehicle, and then remove the rear wheels. 2) Remove the axle nut. CAUTION: Do not loosen the axle nut while the rear axle is loaded. Doing so may damage the hub bearing. Lift the crimped section of axle nut. Remove the axle nut using a socket wrench while de

 Inhibitor Switch

A: INSPECTION When the driving condition or starter motor operation is improper, first check the shift linkage for improper operation. If the shift linkage is functioning properly, check the inhibitor switch. 1) Remove the air intake boot assembly. <Ref. to IN(H4SO)-8, REMOVAL, Air Intake Boo

© 2010-2024 Copyright www.suoutback.com