Subaru Outback (BR): Anti-entrapment function
CAUTION
● Never attempt to test this function using fingers, hands or other parts of your body.
● The anti-entrapment function may not operate properly if some object gets trapped just before the window fully closes.
NOTE
● If a window detects an impact similar to that caused by trapping an object (for example, when the vehicle encounters a deep pothole), the anti-entrapment function may operate.
● The window cannot be operated for a few seconds after the anti-entrapment function operates.
● If the vehicle’s battery is disconnected due to situations such as battery or fuse replacement, the antientrapment function is deactivated.
Initialize the power window to reactivate the anti-entrapment function. Refer to “Initialization of power window” F2-23.
While closing automatically, if the window senses a substantial enough object trapped between the window and the window frame, it automatically moves down slightly and stops.
READ NEXT:
Operating the passengers’ windows
To open:
Press the appropriate switch down and hold it until the window reaches the desired
position.
To close:
Pull the switch up and hold it until the window reaches the desired position.
Locking the passengers’ windows
1) Lock
2) Unlock
To lock:
Press the lock switch. When the lock switch is in the lock position, the passengers’
windows cannot be opened or closed.
To unlock:
Press the lock switch again.
SEE MORE:
Steering Column
A: REMOVAL
1) Adjust the tilt position to the lowest position and lock the tilt lever.
2) Remove the driver's airbag module assembly.
Push in the snap pin using a hexagon wrench or equivalent wrapped with a
protective tape to disengage
the locks (3 locations).
Disconnect the horn harness a
Map light bulb replacing
1. Remove the lens by prying the edge of the lens with a flat-head screwdriver.
2. Turn the bulb until the flat surfaces at its ends are aligned vertically. Pull the bulb straight downward to remove it.
3. Install a new bulb.
4. Reinstall the lens.
