Subaru Outback (BR): Operating the driver’s window
1) Automatically open/close
2) Open/close
To open:
Press the switch down lightly and hold it. The window will open as long as the
switch is held.
This switch also has a one-touch auto down function that allows the window to
be opened fully without holding the switch. Press the switch down until it clicks
and release it, and the window will fully open. To stop the window halfway, pull
the switch up lightly.
To close:
Pull the switch up lightly and hold it. The window will close as long as the
switch is held.
For some models, this switch also has a one-touch auto up function that allows
the window to be closed fully without holding the switch.
Pull the switch up until it clicks and release it, and the window will fully
close. To stop the window halfway, press the switch down lightly.
NOTE
If the vehicle’s battery is disconnected due to situations such as battery or
fuse replacement, the one-touch auto up/down function is deactivated. Initialize
the power window to reactivate the one-touch auto up/down function. Refer to “Initialization
of power window” F2-23.
READ NEXT:
CAUTION
● Never attempt to test this function using fingers, hands or other parts of
your body.
● The anti-entrapment function may not operate properly if some object gets trapped
ju
To open:
Press the appropriate switch down and hold it until the window reaches the desired
position.
To close:
Pull the switch up and hold it until the window reaches the desired position.
1) Lock
2) Unlock
To lock:
Press the lock switch. When the lock switch is in the lock position, the passengers’
windows cannot be opened or closed.
To unlock:
Press the lock switch again.
SEE MORE:
A: INSPECTION
Ignition switch
OFF
ON
Engine start
ABS warning light
Light OFF
Light ON
2 sec.
VDC OFF indicator light
VDC warning light & VDC indicator
light
Several seconds (depending on
engine coolant temperature)
Brake warning light (EBD warning
light)
Parking brake
Release
A: REMOVAL
1) Remove the rear combination light assembly.
Sedan model
1. Remove the trunk room trim. <Ref. to EI-127, REMOVAL, Trunk Room Trim.>
2. Disconnect the connector.
3. Release the nuts and clips, then remove the rear combination light assembly.
CAUTION:
Be careful not to damage t
© 2010-2024 Copyright www.suoutback.com