Subaru Outback (BR): Passive arming
When passive arming mode has been programmed by the dealer, arming of the system is automatically accomplished without using the remote transmitter. Note that in this mode, DOORS MUST BE MANUALLY LOCKED.
READ NEXT:
To enter the passive mode
If you wish to program the passive arming mode, have it done by your SUBARU dealer.
Arming the system
CAUTION
In passive mode, the system will automatically activate the alarm but WILL NOT
automatically lock the doors. In order to lock the doors you must either lock them
as indicated in step 4 be
Tripped sensor identification
The security indicator light flashes when the alarm system has been triggered.
Also, the number of flashes indicates the location of unauthorized intrusion or
the severity of impact on the vehicle
SEE MORE:
Front Speaker
A: REMOVAL
1. FRONT SIDE SPEAKER
1) Disconnect the ground cable from battery.
2) Remove the front side speaker.
Release the clips and claws, then detach the speaker cover.
CAUTION:
Use a plastic clip remover for removal.
Remove the screws.
Preparation tool: Stubby screwdriver
Disconnect the
Washing
CAUTION
● When washing the vehicle, the brakes may get wet. As a result, the brake stopping
distance will be longer. To dry the brakes, drive the vehicle at a safe speed while
lightly pressing the brake pedal to heat up the brakes.
● Do not wash the engine compartment and areas adj
© 2010-2024 Copyright www.suoutback.com
