Subaru Outback (BR): Valet mode
When you choose the valet mode, the alarm system does not operate. In valet mode, the remote transmitter is used only for locking and unlocking the doors and rear gate (Outback) and panic activation.
To enter the valet mode, change the setting of your vehicle’s alarm system for deactivation mode. Refer to “Activating and deactivating the alarm system” F2- 16. The security indicator light will continue to flash once every 3 seconds indicating that the system is in the valet mode.
To exit valet mode, change the setting of your vehicle’s alarm system for activation mode. Refer to “Activating and deactivating the alarm system” F2-16.
READ NEXT:
Passive arming
When passive arming mode has been programmed by the dealer, arming of the system
is automatically accomplished without using the remote transmitter. Note that in
this mode, DOORS MUST BE MANUALLY
To enter the passive mode
If you wish to program the passive arming mode, have it done by your SUBARU dealer.
Arming the system
CAUTION
In passive mode, the system will automatically activate the alarm but WILL NOT
automatically lock the doors. In order to lock the doors you must either lock them
as indicated in step 4 be
SEE MORE:
Engine Control Module (ECM) I/O Signal
A: ELECTRICAL SPECIFICATION
Input/output name:
Crankshaft position sensor
Camshaft position sensor
Measuring condition:
After warming-up
At idling
Engine Condition Data
A: ELECTRICAL SPECIFICATION
Measuring condition:
After engine is warmed up.
Set the select lever in "P" range
START
CAUTION
Do not turn the ignition switch to the “START” position while the engine is running.
The engine is started in this position. The starter cranks the engine to start
it. When the key is released (after the engine has started), the key automatically
returns to the “ON” position.
© 2010-2025 Copyright www.suoutback.com
