Subaru Outback (BR): Front passenger’s seat (if equipped)
Subaru Outback (BR) 2010-2015 Owners Manual / Seat, seatbelt and SRS airbags / Front seats / Power seat (if equipped) / Front passenger’s seat (if equipped)
1) Seat position forward/backward control switch To adjust the seat forward or backward, move the control switch forward or backward.
2) Seatback angle (reclining) control switch To adjust the angle of the seatback, move the control switch.
READ NEXT:
Head restraint adjustment
1) Head restraint
2) Release button
Both the driver’s seat and the front passenger’s seat are equipped with head
restraints.
The head restraint should be adjusted so that the center of the
Seat heater (if equipped)
1) HIGH – Rapid heating
2) LOW – Normal heating
3) OFF – Off
A) Left-hand side
B) Right-hand side
The seat heater operates when the ignition switch is either in the “Acc” or “ON”
Rear seats
WARNING
Seatbelts provide maximum restraint when the occupant sits well back and upright
in the seat. Do not put cushions or any other materials between occupants and seatbacks
or seat cushions
SEE MORE:
ABS warning light
The ABS warning light illuminates when the ignition switch is turned to the “ON”
position and turns off after approximately 2 seconds.
This is an indication that the ABS system is working properly.
CAUTION
● If any of the following conditions occur, we recommend that you have the AB
Evaporator
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Using the refrigerant recovery system, discharge refrigerant. <Ref. to AC-24,
PROCEDURE, Refrigerant
Recovery Procedure.>
3) Drain the coolant from the radiator.
H4 non-turbo model: <Ref. to CO(H4SO)-14, DRAINING OF ENGINE COOL
© 2010-2024 Copyright www.suoutback.com
