Subaru Outback (BR): Seat height adjustment (driver’s seat)
Subaru Outback (BR) 2010-2015 Owners Manual / Seat, seatbelt and SRS airbags / Front seats / Manual seat / Seat height adjustment (driver’s seat)
1) When the lever is pushed down, the seat is lowered.
2) When the lever is pulled up, the seat rises.
The height of the seat can be adjusted by moving the seat cushion adjustment lever up or down.
READ NEXT:
Power seat (if equipped)
WARNING
To prevent the passenger from sliding under the seatbelt in the event of a collision,
always put the seatback in the upright position while the vehicle is in motion.
Also, do not place
Driver’s seat
1) Seat position forward/backward control switch
To adjust the seat forward or backward, move the control switch forward or backward.
During forward/backward adjustment of the seat, you cannot ad
Front passenger’s seat (if equipped)
1) Seat position forward/backward control switch
To adjust the seat forward or backward, move the control switch forward or backward.
2) Seatback angle (reclining) control switch
To adjust the an
SEE MORE:
Steering Wheel
A: REMOVAL
1) Disconnect the negative terminal from the battery, and wait for 60 seconds
or more.
2) Set the tire to the straight-ahead position.
3) Remove the driver's airbag module assembly.
Push in the snap pin using a hexagon wrench or equivalent wrapped with a
protective tape to disengag
Headlight Assembly
A: REMOVAL
CAUTION:
Do not perform work with wet hands.
1) Disconnect the ground cable from battery.
2) Remove the clips and remove the air intake duct. (When removing the headlight
RH)
3) Remove the front bumper face assembly. <Ref. to EI-39, REMOVAL, Front
Bumper.>
4) Remove the fender
© 2010-2024 Copyright www.suoutback.com
