Subaru Outback (BR): Seatbelt and SRS airbag
WARNING
● All persons in the vehicle should fasten their seatbelts BEFORE the vehicle starts to move. Otherwise, the possibility of serious injury becomes greater in the event of a sudden stop or accident.
● To obtain maximum protection in the event of an accident, the driver and all passengers in the vehicle should always wear seatbelts when the vehicle is moving. The SRS (Supplemental Restraint System) airbag does not do away with the need to fasten seatbelts. In combination with the seatbelts, it offers the best combined protection in case of a serious accident.
Not wearing a seatbelt increases the chance of severe injury or death in a crash even when the vehicle has the SRS airbag.
● The SRS airbags deploy with considerable speed and force. Occupants who are out of proper position when the SRS airbag deploys could suffer very serious injuries. Because the SRS airbag needs enough space for deployment, the driver should always sit upright and well back in the seat as far from the steering wheel as practical while still maintaining full vehicle control and the front passenger should move the seat as far back as possible and sit upright and well back in the seat.
For instructions and precautions, carefully read the following sections.
● For the seatbelt system, refer to “Seatbelts” F1-12.
● For the SRS airbag system, refer to “*SRS airbag (Supplemental Restraint System airbag)” F1-38.
READ NEXT:
Child safety
WARNING
● Never hold a child on your lap or in your arms while the vehicle is moving.
The passenger cannot protect the child from injury in a collision, because the child
will be caught bet
Drinking and driving
WARNING
Drinking and then driving is very dangerous. Alcohol in the bloodstream delays
your reaction and impairs your perception, judgment and attentiveness. If you drive
after drinking – even
SEE MORE:
Reverse Idler Gear
REMOVAL
1) Remove the manual transmission assembly
from the vehicle. <Ref. to 6MT-25, REMOVAL,
Manual Transmission Assembly.>
2) Remove the back-up light switch neutral position
switch. <Ref. to 6MT-37, REMOVAL, Switches and
Harness.>
3) Remove the transfer case together with the exten
General Description of Vehicle Dynamics Control
A: SPECIFICATION
B: COMPONENT
1. ABS WHEEL SPEED SENSOR
Front ABS wheel speed sensor
Front axle housing
Rear ABS wheel speed sensor
Rear axle housing
Hub unit bearing
Magnetic encoder
Tightening torque:N*m (kgf-m, ft-lb)
T: 7.5 (0.76, 5.5)
2. STEERING ANGLE
