Subaru Outback (BR): Replacing bulbs
WARNING
Bulbs may become very hot while illuminated. Before replacing bulbs, turn off
the lights and wait until the bulbs cool down, Otherwise, there is the risk of sustaining
a burn injury.
CAUTION
Replace any bulb only with a new bulb of the specified wattage. Using a bulb
of different wattage could result in a fire. For the specified wattage of each bulb,
refer to “Bulb chart” F12-14.
READ NEXT:
CAUTION
Halogen headlight bulbs become very hot while in use. If you touch the bulb surface
with bare hands or greasy gloves, fingerprints or grease on the bulb surface will
develop into hot spot
1. Pull off the fender lining. For details, refer to “Pulling off the fender
lining” F11- 7.
2. Remove the bulb cover, by turning it counterclockwise.
3. Disconnect the electrical connecto
1. Remove the air intake duct (right-hand side). For the method to remove the
air intake duct, refer to “Removing air intake duct” F11-7.
Left-hand side
2. Use a screwdriver to remove the se
SEE MORE:
General Description
A: COMPONENT
Glass lid
Weather strip
Lid cover
Sunshade
Drain tube
Motor ASSY
Frame ASSY
Deflector
Drain plate
Stopper rubber
Link ASSY
Lid bracket
Tightening torque: N*m (kgf-m, ft-lb)
T1: 4.5 (0.46, 3.3)
T2: 6.0 (0.61, 4.4)
B: CAUTION
Before disassembling or re
A: REMOVAL
CAUTION:
Be sure to prevent water or oil from contacting the connector terminal of
secondary speed sensor. If
adhesion occurs, replace with a new part.
1) Remove the transmission from the vehicle. <Ref. to CVT-55, REMOVAL,
Automatic Transmission Assembly.>
2) Remove the transmiss
© 2010-2025 Copyright www.suoutback.com
