Subaru Outback (BR): If no steam is coming from the engine compartment
NOTE
For details about how to check the coolant level or how to add coolant, refer to “Engine coolant” F11-17.
1. Keep the engine running at idling speed.
2. Open the hood to ventilate the engine compartment. Refer to “Engine hood” F11-7.
Confirm that the cooling fan is turning. If the fan is not turning, immediately turn off the engine and contact your authorized dealer for repair.
3. After the engine coolant temperature has dropped, turn off the engine. If the coolant temperature high warning light illuminates, turn off the engine.
4. After the engine has fully cooled down, check the coolant level in the reserve tank.
If the coolant level is below the “LOW” mark, add coolant up to the “FULL” mark.
5. If there is no coolant in the reserve tank, add coolant to the reserve tank. Then remove the radiator cap and fill the radiator with coolant.
If you remove the radiator cap from a hot radiator, first wrap a thick cloth around the radiator cap, then turn the cap counterclockwise slowly without pressing down until it stops. Release the pressure from the radiator. After the pressure has been fully released, remove the cap by pressing down and turning it.
READ NEXT:
Towing
WARNING
Never tow AWD vehicles (including AT, MT and CVT) with the front wheels raised
off the ground while the rear wheels are on the ground, or with the rear wheels
raised off the ground while
Towing and tie-down hooks/holes
The towing hooks should be used only in an emergency (e.g., to free a stuck vehicle
from mud, sand or snow).
CAUTION
● Use only the specified towing hooks and tie-down hooks/holes. Never use
Using a flat-bed truck
This is the best way to transport your vehicle. Use the following procedures
to ensure safe transportation.
1. Shift the select lever into the “P” position for AT and CVT models or the
shif
SEE MORE:
Auto-dimming mirror with compass and HomeLink® (if equipped)
1) HomeLink® button 1
2) HomeLink® button 2
3) LED
4) HomeLink® button 3
5) Sensor
6) Automatic dimming on/off button
7) Compass display button
8) Compass display
The auto-dimming mirror has an anti-glare feature which automatically reduces
glare coming from headlights of vehicles beh
MT models
1. Apply the parking brake.
2. Turn off unnecessary lights and accessories.
3. Depress the clutch pedal to the floor and shift the shift lever into neutral.
Hold the clutch pedal to the floor while starting the engine. The starter motor
will only operate when the clutch pedal is depressed full
