Subaru Outback (BR): Airflow mode selection button
Select the desired airflow mode by pressing the airflow mode selection button. The selected airflow mode is shown on the display.
There are four airflow modes that activate the following air outlets.
(Ventilation): Instrument panel
outlets
(Bi-level): Instrument panel outlets
and foot outlets
(Heat): Foot outlets, both side
outlets of the instrument panel and some through windshield defroster outlets (A
small amount of air flows to the windshield and both side windows to prevent fogging.)
(Heat-def): Windshield defroster
outlets, foot outlets and both side outlets of the instrument panel
NOTE
When the “
” mode is selected, the
air conditioner compressor automatically operates to quickly defog the windshield
and the air inlet selection is automatically set to the “outside air” mode.
READ NEXT:
Air inlet selection button (Automatic climate control system)
Select airflow by pressing the air inlet selection button “”.
ON position (recirculation): Interior air is recirculated inside the vehicle. Press the air inlet selectio
Temperature sensors
1) Solar sensor
2) Interior air temperature sensor
The automatic climate control system employs several sensors. These sensors are
delicate. If they are treated incorrectly and become damaged, t
SEE MORE:
Woofer
A: REMOVAL
1. SEDAN MODEL
NOTE:
harman/kardon audio system only.
1) Disconnect the ground cable from battery.
2) Remove the rear shelf trim. <Ref. to EI-120, REMOVAL, Rear Shelf Trim.>
3) Remove the woofer.
Remove the screws.
Disconnect the harness connector and remove the woofer assembly
Starting your vehicle
NOTE
All vehicle doors, the engine hood and trunk / rear gate must be closed prior
to activating the remote engine start system. Any open entry point will prevent
starting or cause the system to shut down.
The remote engine start function is activated by pressing the “”
button twice wi
