Subaru Outback (BR): Cooling or dehumidifying
For cooling and dehumidification of the passenger compartment, air flows through
the instrument panel outlets:
1. Set the air inlet selection button to the OFF position.
2. Press the “” button.
3. Set the air conditioner button to the “ON” position.
4. Set the temperature control dial to the blue side.
5. Set the fan speed control dial at the desired speed.
READ NEXT:
To direct warm air to the windshield and front door windows:
1. Press the “” button.
2. Set the temperature control dial to the red side.
3. Set the fan speed control dial at the highest speed.
NOTE
● Operate the automatic climate control system when the engine is running.
● The blower fan rotates at a low speed when the engine coolant temperature is
low.
For efficient defog
1) Temperature control button (driver’s side) 2) Dual mode button
3) Airflow mode selection button 4) Fan speed control button 5) Temperature control button (front passenger’s s
SEE MORE:
A: REMOVAL
1) Lift up the vehicle, and then remove the rear wheels.
2) Remove the rear stabilizer.
Remove left and right stabilizer links.
Detach the stabilizer clamp and remove the rear stabilizer.
B: INSTALLATION
CAUTION:
Be sure to use a new flange nut and self-locking nut.
Always tighte
DA:DTC P1160 RETURN SPRING FAILURE
NOTE:
For the diagnostic procedure, refer to DTC P2101. <Ref. to EN(H4SO)(diag)-267,
DTC P2101 THROTTLE
ACTUATOR CONTROL MOTOR CIRCUIT RANGE/PERFORMANCE, Diagnostic Procedure with
Diagnostic
Trouble Code (DTC).>
DB:DTC P1443 VENT CONTROL SOLENOID VALVE FUNC
© 2010-2024 Copyright www.suoutback.com