Subaru Outback (BR): Windshield wipers
MIST : Mist (for a single wipe)
OFF : Off
INT: Intermittent
LO: Low speed
HI: High speed
To turn the wipers on, push the wiper control lever down.
To turn the wipers off, return the lever to the “OFF” position.
For a single wipe of the wipers, push the lever up. The wipers operate until you release the lever.
READ NEXT:
Wiper intermittent time control
When the wiper switch is in the “INT” position, turn the dial to adjust the operating
interval of the wiper. The operating interval can be adjusted in five steps from
the shortest interval t
Windshield washer
To wash the windshield, pull the wiper control lever toward you. The washer fluid
sprays until you release the lever. The wipers operate while you pull the lever.
NOTE
The windshield washer fl
Rear window wiper and washer switch (Outback)
: Washer (accompanied by wiper operation)
ON: Continuous INT: Intermittent OFF: Off
: Washer (accompanied by wiper operation)
SEE MORE:
Front Vehicle Speed Sensor
A: REMOVAL
1) Remove the transmission assembly from the vehicle.
<Ref. to 5AT-37, REMOVAL, Automatic
Transmission Assembly.>
2) Disconnect the rear vehicle speed sensor connector.
NOTE:
Secure the transmission harness to the transmission
body using wire etc.
3) Remove the extension case.
Using a flat-bed truck
This is the best way to transport your vehicle. Use the following procedures
to ensure safe transportation.
1. Shift the select lever into the “P” position for AT and CVT models or the
shift lever into “1st” for MT models.
2. Apply the parking brake.
3. Secure the vehicle onto the c
© 2010-2024 Copyright www.suoutback.com
