Subaru Outback (BR): Cruise control set indicator light
Subaru Outback (BR) 2010-2015 Owners Manual / Instruments and controls / Warning and indicator lights / Cruise control set indicator light
The cruise control set indicator light illuminates when the ignition switch is turned to the “ON” position and turns off after approximately 3 seconds.
This light illuminates when vehicle speed has been set.
READ NEXT:
Headlight indicator light
This indicator light illuminates under the following conditions.
● when the light switch is turned to the “”
or “” position
● when the light switch is in the “AUTO” posit
Front fog light indicator light (if equipped)
This indicator light illuminates while the front fog lights are illuminated.
Clock
NOTE
Your SUBARU dealer can change the settings of activating/deactivating the automatic
adjustment of the clock by the GPS (Global Positioning System) (for models with
the genuine SUBARU navigat
SEE MORE:
Inspection Mode
A: PROCEDURE
Perform the diagnosis shown in the following DTC table.
When performing the diagnosis not listed in "List of Diagnostic Trouble Code (DTC)",
refer to the item on the
drive cycle. <Ref. to EN(H4SO)(diag)-45, Drive Cycle.>
1. PREPARATION FOR THE INSPECTION
MODE
1) Check that the
If you park your vehicle in an emergency
The hazard warning flasher should be used in day or night to warn other drivers
when you have to park your vehicle under emergency conditions.
Avoid stopping on the road. It is best to safely pull off the road if a problem
occurs. The hazard warning flasher can be activated regardless of the
© 2010-2024 Copyright www.suoutback.com
