Subaru Outback (BR): To arm the system using remote transmitter
1. Close all windows and the moonroof (if equipped).
2. Remove the key from the ignition switch.
3. Open the doors and get out of the vehicle.
4. Make sure that the engine hood (and the trunk lid (Legacy)) are locked.
5. Close all doors (and the rear gate (Outback)).
6. Briefly press the “” button (for
less than 2 seconds). All doors (and the rear gate (Outback)) will lock, an electronic
chirp will sound once, the turn signal lights will flash once, and the security
indicator light will start flashing rapidly. After rapid flashing for 30 seconds
(standby time), the security indicator light will then flash slowly (twice approximately
every 2 seconds), indicating that the system has been armed for surveillance.
If any of the doors (rear gate or trunk lid) is not fully closed, an electronic
chirp sounds five times, the turn signal lights flash five times to alert you that
the doors (or the rear gate) are not properly closed. When you close the door, the
system will automatically arm and doors will automatically lock.
READ NEXT:
1. Close all windows.
2. Remove the key from the ignition switch.
3. Open the doors and get out of the vehicle.
4. Make sure that the engine hood is locked.
5. Close the doors (and the rear gate (
Briefly press the “” button (for
less than 2 seconds) on the remote transmitter. The driver’s door will unlock, an
electronic chirp will sound twice, the turn signal lights will flash twice
If you cannot disarm the system using the transmitter (i.e. the transmitter is
lost, broken or the transmitter battery is too weak), you can disarm the system
without using the transmitter.
The s
SEE MORE:
WARNING
Objects look smaller in a convex mirror and farther away than when viewed in
a flat mirror. Do not use the convex mirror to judge the distance of vehicles behind
you when changing lanes. Use the inside mirror (or glance backwards) to determine
the actual size and distance of objects t
Non-turbo models
1) Yellow handle
Turbo models
1) Yellow handle
Check the oil level monthly.
1. Park the vehicle on a level surface and stop the engine.
2. Pull out the level gauge, wipe it clean, and insert it again.
1) Upper level
2) Lower level
3. Withdraw t
© 2010-2024 Copyright www.suoutback.com