Subaru Outback (BR): System alarm operation
The alarm system will give the following alarms when triggered:
● The vehicle’s horn will sound and the turn signal lights will flash for 30 seconds.
● If any door (or the rear gate/trunk lid) remains open after the 30-second period, the horn will continue to sound for a maximum of 3 minutes. If the door (or the rear gate/trunk lid) is closed while the horn is sounding, the horn will stop sounding with a delay of up to 30 seconds.
The alarm is triggered by:
● Opening a door, the rear gate or trunk lid ● Physical impact to the vehicle, such as forced entry (only models with shock sensors (dealer option))
NOTE
The alarm system can be set to trigger illumination of map lights and dome light. The map lights and dome light notification is deactivated as the factory setting. Refer to “Function settings” F20. A SUBARU dealer can activate the system. Contact your SUBARU dealer for details.
READ NEXT:
Activating and deactivating the alarm system
To change the setting of your vehicle’s alarm system for activation or deactivation,
do the following.
1. Disarm the alarm system. Refer to “Disarming the system” F2-18.
2. Sit in the driver
If you have accidentally triggered the alarm system
To stop the alarm
Perform any of the following operations.
● Press any button on the remote transmitter.
● Turn the ignition switch to the “ON” position.
SEE MORE:
DTC P0128, P0131, P0132, P0133, P0134, P0137, P0138, P013A, P013B, P013E,
P013F, P0140, P0141, P014C, P014D, P015A, P015B, P0171, P0172, P0181, P0182,
P0183, P0196, P0197, P0198, P0201
AA:DTC P0128 COOLANT THERMOSTAT (ENGINE COOLANT TEMPERATURE
BELOW THERMOSTAT REGULATING TEMPERATURE)
DTC DETECTING CONDITION:
Detected when two consecutive driving cycles with fault occur.
GENERAL DESCRIPTION <Ref. to GD(H4SO)-55, DTC P0128 COOLANT THERMOSTAT
(ENGINE
COOLANT TEMPERATURE BEL
Outback License plate light
1. Remove the mounting screws using a Phillips screwdriver.
2. Remove the lens.
3. Pull the bulb out of the socket.
4. Install a new bulb.
5. Reinstall the lens.
6. Tighten the mounting screws.
