Subaru Outback manuals

Subaru Outback (BR): Behavior with key lock-in prevention function non-operational

● If the lock lever is turned to the rear (“LOCK”) position with the driver’s door open and the driver’s door is then closed with the lock lever in that position, the driver’s door is locked. . If the spare key is used to lock the driver’s door from the outside of the vehicle, the door is locked. This function’s operational/non-operational setting can be changed by a SUBARU dealer. Contact a SUBARU dealer for details.

NOTE

● The factory setting (default setting) for this function is set as “operational”.

● When leaving the vehicle, make sure you are holding the key before locking the doors.

READ NEXT:

 Remote keyless entry system

CAUTION ● Do not expose the remote transmitter to severe shocks, such as those experienced as a result of dropping or throwing. ● Do not take the remote transmitter apart except when r

 Locking the doors

Press the “” button to lock all doors and rear gate (Outback). An electronic chirp will sound once and the turn signal lights will flash once. If any of the doors (or the rear gate/trunk li

 Unlocking the doors

Press the “” button to unlock the driver’s door. An electronic chirp will sound twice and the turn signal lights will flash twice. To unlock all doors and the rear gate (Outback), briefly

SEE MORE:

 Outside temperature indicator

1) U.S.-spec. models 2) Except U.S.-spec. models The outside temperature indicator shows the outside temperature in a range from −22 to 1228F (−30 to 508C). The indicator can give a false reading under any of the following conditions: ● When there is too much sun. ●

 Rearview Camera System

A: WIRING DIAGRAM Refer to "Rearview Camera System" in the wiring diagram. <Ref. to WI-213, WIRING DIAGRAM, Rearview Camera System.> B: REMOVAL 1. SEDAN MODEL 1) Disconnect the ground cable from battery. 2) Remove the trunk lid trim. Remove the trunk handle. Remove the clips and the trunk

© 2010-2024 Copyright www.suoutback.com