Subaru Outback (BR): Seatbelt warning light and chime
NOTE
If your seatbelt warning device does not operate as described in the following,
it may be out of order. Have the device inspected and, if necessary, repaired by
the nearest SUBARU dealer.
Your vehicle is equipped with a seatbelt warning device at the driver’s and front
passenger’s seat, as required by current safety standards.
With the ignition switch turned to the “ON” position, this device reminds the
driver and front passenger to fasten their seatbelts by the warning lights in the
locations indicated in the following illustration and a chime.
Driver’s warning light
Front passenger’s warning light
READ NEXT:
If the driver and/or front passenger have/ has not yet fastened the seatbelt(s)
when the ignition switch is turned to the “ON” position, the seatbelt warning light(s)
will flash for 6 seconds,
WARNING
● Never use a belt that is twisted or reversed. In an accident, this can increase
the risk or severity of injury.
● Keep the lap belt as low as possible on your hips. In a coll
1. Adjust the seat position:
Driver’s seat: Adjust the seatback to the upright position. Move the seat as
far from the steering wheel as practical while still maintaining full vehicle control.
SEE MORE:
A: REMOVAL
1) Remove the door trim. <Ref. to EI-60, REMOVAL, Door Trim.>
2) Remove the screws and detach the rear inner remote handle.
B: INSTALLATION
1) Before installation, check the following items.
Cable is free from deformation such as fray.
Grease is applied sufficiently to cable jo
Driver’s side
Passenger’s side
To increase the temperature setting, press the “”
side of the temperature control button. To decrease the temperature setting, press
the “” side of the temperature control
button.
Each temperature setting is shown on the display. When the “LO
© 2010-2024 Copyright www.suoutback.com