Non-turbo models
1) Connector
2) Clip
3) Clamp
4) Air intake boot
5) Clip
1. Unplug the connector that is attached to the top of the air cleaner case.
2. Detach the connector cable from the clip on the right side on the air cleaner case.
3. Loosen the screw of the clamp and pull the air intake boot out of the air cleaner case.
4. Unsnap the two clips holding the air cleaner case cover.
5. Open the air cleaner case and remove the air cleaner element.
6. Clean the inside of the air cleaner case and case cover with a damp cloth and install a new air cleaner element.
7. To install the air cleaner case, insert the three projections on the air cleaner case into the slits on the air cleaner case cover.
8. Install in the reverse order of removal.
See also:
Floor mat (if equipped)
Floor mat (if equipped)
Retaining pins are located on the driver’s side floor.
The floor mat is secured using the built-in grommets, by placing the grommets over the pins and pushing them downward.
...
Control panel
1) Fan speed control dial
2) Temperature control dial
3) Airflow control buttons
4) Air conditioner button
5) Air inlet selection button
6) Rear window defogger button (Refer to “Defogger and d ...
Fan speed control dial
The fan operates only when the ignition switch is turned to the “ON” position.
The fan speed control dial is used to select four fan speeds. ...