Compass calibration
1. If a “C” is displayed in the compass window, the compass needs to be calibrated.
2. Drive the vehicle in a circle at 5 mph (8 km/h) or less until the display reads a direction.
3. You can also calibrate the compass by driving your vehicle on your everyday routine. The compass will be calibrated once it has tracked a complete circle.
4. To recalibrate your compass, push and hold the compass display button for 9 seconds until a “C” appears in the compass window.
5. Calibrate the compass according to step 2 or step 3.
See also:
Unlocking the rear gate (Outback)
Pressing the “” button unlocks the
rear gate.
An electronic chirp will sound twice and the turn signal lights will flash twice. ...
To disengage the service mode
Turn the ignition switch to the “ON” position, depress and hold the brake pedal, then press and release the “” button on the remote engine start transmitter three times. The system will pause for 1 se ...
Cruise control
Cruise control enables you to maintain a constant vehicle speed without holding
your foot on the accelerator pedal and it is operative when the vehicle speed is
25 mph (40 km/h) or more.
WARNING
...