Subaru Outback manuals

Subaru Outback (BR): Bulb chart

NOTE


NOTE

Lights A and B are the LED (Light Emitting Diode) type. Consult your SUBARU dealer for replacement.


WARNING


WARNING

Bulbs may become very hot while illuminated. Before replacing bulbs, turn off the lights and wait until the bulbs cool down. Otherwise, there is the risk of sustaining a burn injury.

CAUTION

Replace any bulb only with a new bulb of the specified wattage. Using a bulb of different wattage could result in a fire.

READ NEXT:

 Vehicle identification

1) Emission control label 2) Vehicle identification number 3) Certification and bar code label 4) Tire inflation pressure label 5) Vehicle identification number plate 6) Model number label 7)

 Consumer information and Reporting safety defects

 For U.S.A

The following information has been compiled according to Code of Federal Regulations “Title 49, Part 575”.

SEE MORE:

 Ignition Switch Illumination

A: REMOVAL 1) Disconnect the ground cable from battery. 2) Remove the steering column cover. Remove the screws by turning the steering wheel to right and left. Release the claws and remove the steering column lower cover. Separate the steering column upper cover and steering upper cover,

 Rear Wiper Arm

A: REMOVAL 1) Pull up the wiper arm cover. 2) Remove the nut and remove the wiper arm. B: INSTALLATION 1) Install in the reverse order of removal. 2) Operate the rear wiper once. 3) Align the blade with the marking on the glass. Tightening torque: Refer to "COMPONENT" of "General Description".

© 2010-2024 Copyright www.suoutback.com