Subaru Outback (BR): Fluids
*1: Use one of the indicated types of fluid.
*2: The indicated fluid quantity is only a guideline. The necessary quantity for replacement may differ slightly depending on the temperature and other factors.
*3: For more details about maintenance and service, refer to the indicated section.
READ NEXT:
Engine coolant - Subaru super coolant
The specified coolant quantity serves as a general reference and may vary slightly based on temperature and other variables. For comprehensive information regarding maintenance and servici
Tires specification in the table
*1: This torque is equivalent to applying approximately 88 to 110 lbf (40 to 50 kgf) at the end of the wheel nut wrench. If you have tightened the wheel nuts by yourself, have the tighteni
SEE MORE:
Front Hood
A: REMOVAL
1. FRONT HOOD INSULATOR
Release the clips to remove the front hood insulator.
CAUTION:
Do not reuse any clips damaged during removal. The damaged clip cannot fix the
insulator securely.
Therefore, always replace with a new part.
2. FRONT HOOD SEAL
Remove the clip, and remove the seal.
Tail/Back-up light (Outback)
1. Apply a flat-head screwdriver to the light cover as shown in the illustration,
and pry the light cover off from the rear gate trim.
1) Back-up light
2) Tail light
2. Turn the bulb socket counterclockwise and remove it.
3. Pull the bulb out of the bulb socket and replace it with a new
© 2010-2024 Copyright www.suoutback.com
